M A T E R I A L S A F E T Y D A T A S H E E T
Prod.ID:
02007 Page 2
================== SECTION I - PRODUCT IDENTIFICATION =================
PRODUCT NAME: INT/EXT WEATHERONE HMIS CODES: H C F R P
COVERCOAT FLAT BLACK
LATEX
PRODUCT 02007 1 0 0 B
IDENTIFIER:
PRODUCT USE: General purpose water-based coating.
WHMIS INFO: NON-CONTROLLED
MANUFACTURER'S NAME: Cloverdale Paint Inc
ADDRESS : 6950 King George Boulevard
Surrey, BC,
EMERGENCY PHONE : 613-996-6666 REVISION DATE : 12-Jul-12
INFORMATION PHONE : 604-596-6261
ABREVIATIONS N/AP ñ NOT APPLICABLE N/AV ñ NOT AVAILABLE
:
================== SECTION II - HAZARDOUS INGREDIENTS
=====================
REPORTABLE CAS WEIGHT O.E.L.
COMPONENTS NUMBER PERCENT
CARBON BLACK 1333-86- 1-5 ACGIH TLV: 3.5 mg/m3
PIGMENT 4 LD50: >15400 mg/kg rat-oral
----------------------------------------------------------------------------
------
*** No toxic chemical(s) subject to the reporting requirements of section
313 of Title III and of 40 CFR 372 are present. ***
----------------------------------------------------------------------------
------
=============== SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
============
BOILING POINT: Not available. SPECIFIC GRAVITY 1.20
(H2O=1):
VAPOR DENSITY: Heavier than PHYSICAL STATE: Liquid.
air.
EVAPORATION Slower than n-
RATE: Butyl Acetate.
COATING V.O.C.: 112 g/l
(before
thinning)
SOLUBILITY IN Soluble.
WATER:
APPEARANCE AND Moderately thick liquid; Sweet, slightly
ODOR: ammoniacal odor.
FREEZING POINT: 0 deg C pH: 8.75
COEFFICIENT OF WATER/OIL DIST: ODOR THRESHOLD: Not available.
N/AV
================= SECTION IV - FIRE AND EXPLOSION HAZARD DATA
==============
FLASH POINT: N/AP METHOD USED: N/AP
FLAMMABLE LIMITS IN AIR BY VOLUME- LOWER: N/AP UPPER: N/AP
EXTINGUISHING MEDIA:
Use extinguishing media appropriate to surrounding fire.
SPECIAL FIREFIGHTING PROCEDURES
Handle as a non-flammable liquid. .
UNUSUAL FIRE AND EXPLOSION HAZARDS
Closed containers may explode when exposed to extreme heat.
FLAMMABILITY ñ T.D.G.R. CLASS:
Not regulated.
SENSITIVITY TO IMPACT: NO
AUTO-IGNITION TEMPERATURE:
Not available
SENSITIVITY TO STATIC DISCHARGE: Not available.
HAZARDOUS COMBUSTION PRODUCTS:
Not available.
======================== SECTION V - REACTIVITY DATA
=======================
CHEMICAL STABILITY: STABLE
CONDITIONS TO AVOID:
Excessive heat, poor ventilation, corrosive atmospheres, excessive
aging.
INCOMPATIBILITY (MATERIALS TO AVOID)
Alkaline materials, strong acids and oxidizing agents.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: NONE KNOWN
HAZARDOUS POLYMERIZATION:
Will not occur.
==================== SECTION VI - TOXICOLOGICAL DATA
=======================
INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Excessive exposure to vapours or spray mists may cause minor
irritation to the eyes, nose and throat.
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE
Eye Contact: May cause minor irritation, tearing, redness and blurred
vision. Skin Contact: May cause minor irritation.
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
May dry and defat skin causing cracks, irritation and dermatitis.
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE
May cause gastrointestinal irritation, vomiting, nausea and diarrhea.
HEALTH HAZARDS (ACUTE AND CHRONIC)
Acute health hazards are as listed above. Chronic: Overexposure to
Carbon Black may cause heart and lung damage.
SENSITIZING CAPABILITY: NONE KNOWN
CARCINOGENICITY: NTP CARCINOGEN:No IARC MONOGRAPHS:No OSHA
REGULATED:No
No carcinogenic effects have been found in animals or humans due to
exposure to commercial Carbon Black. Carbon Black does contain trace
amounts of strongly absorbed polynuclear aromatic compounds (PNA'S).
Some PNA'S in the non-absorbed form have been found to be
carcinogenic.
TERATOGENICITY AND EMBRYOTOXICITY
Not available.
REPRODUCTIVE TOXICITY
Not available.
MUTAGENICITY
Not available.
TOXICOLOGICALLY SYNERGISTIC PRODUCTS
None known.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE
Anesthesia, respiratory tract irritation, dermatitis, nausea,
vomiting.
ADDITIONAL HEALTH INFORMATION
Not available.
================= SECTION VII - PREVENTIVE MEASURES
=======================
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Clean up with water before allowing to dry. Sodium Chloride can be
sprinkled on the spill, which may coagulate the latex and facilitate
cleaning with water. Place coagulated waste in a closed container.
Flush area with water.
WASTE DISPOSAL METHOD
Reclaim or dispose of through a licensed waste disposal company
according to Federal,Provincial and local regulations.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Storage: Keep from freezing. Store in a well ventilated area out of
direct sunlight and away from any source of heat. Handling:
Avoid prolonged or repeated inhalation of heated vapours or spray
mist. Avoid prolonged or repeated skin contact. Wear adequate personal
protective equipment.
OTHER PRECAUTIONS: Not available.
RESPIRATORY PROTECTION
Not normally required when applying by brush or roller. When spraying,
wear a mist/dust particulate respirator. In cases of poor or no
ventilation, wear a respirator NIOSH approved for organic vapours and
particulates.
VENTILATION
General (dilution) ventilation is required during use. Local exhaust
ventilation is required during operations where this material is
heated.
PROTECTIVE GLOVES
Rubber.
EYE PROTECTION
Chemical safety glasses, goggles or face shield.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT
Use impermeable aprons and protective clothing whenever possible to
prevent skin contact.
WORK/HYGIENIC PRACTICES
Eye washes and safety showers in the workplace are recommended.
===================== SECTION VIII - FIRST AID MEASURES
=====================
INHALATION OVEREXPOSURE: Move person to fresh air. If breathing stops,
apply artificial respiration and seek immediate medical attention.
EYE CONTACT: Flush with water for at least 15 minutes. Seek medical
attention.
SKIN CONTACT: Wash thoroughly with mild soap and water.
INGESTION: Drink 1 or 2 glasses of water to dilute. Contact a
physician immediately.
========================= SECTION IX - PREPARATION
========================
PREPARED BY: TECHNICAL DEPARTMENT
========================= SECTION X - DISCLAIMER
==========================
To the best of our knowledge, the information contained herein is
accurate, obtained from sources believed by Cloverdale Paint Inc. to
be accurate. No warranty concerning the accuracy of these sources is
made and Cloverdale Paint Inc. will not be held liable for claims
relating to use of this information or recommendations.